Details of our engine shed. Assembled using the Durox block glue block system to follow as we build it. Meantime a few pictures of the shed at the end of my garden built using the same method.

http://www.tarmac.co.uk/topblock/DuroxSystemproduct.aspx

Durox blocks are water resistant and can be used on the external face of a building. Usually they are rendered but for a shed all that is needed is a coat of masonry paint. Quick, solid and isn't going to rot in 10 years time.

As we were un able to obtain the Supasystem (large blocks) we used standard size blocks. Only difference is the extra glue required.

	Foundation construction 200mm of hardcoare Sand blinding then compacted with a wacker plate Polythene 180mm reinforced concrete
	Shed before painting and felt roof. Canopy only existed as we were too lazy to cut the 3m long joists. Fascia is made of plastic and cut with a hole cutter and a jigsaw. The engineering bricks have two purposes act as a damproof course without weakening the structure. Create a level finish for the block sytem to be set on to.
	There are limits to how nuch of the elements you can keep out. Thames Water pushed it to the limit four times but still blamed it on customers actions (ie wont pay for damage caused). How many customers put gulley gratings and broom heads down the sewers?? Oh the joy of a private monopoly. External finish is Hi Build - a thick textured paint which can be applied with a float before finishing with a paint roller.

Some simple notes on Masonry.

• It is wrong to assume the more cement in mortar the better. 1 cement to 6 sand is more than enough strenght for most construction purposes. If you make the mortar too strong, if there is any settlement then the bricks or blocks will break as against simply settleling.
• Garden wall foundations - the deeper you go the better. At least try to go down a foot so you clear the vegetation layers, where most of the ground movement happens.
• Plasticiser additive. This is a mild detergent that makes the sand and cement more fluid and requiring less water (less staining when you get it on the face of the brick). For years you would catch brick layers on site adding fairy liquid. Of course I can't recommend that!!!!
• Mixing concrete and mortar by hand is not easy. Rent a mixer in if you are going to anything larger than a couple of dozen of brick. If you are careful you can lay bricks on concrete foundations laid the day before - eg Saturday/Sunday project.

A standard brick

• Front Face (Stretcher) 65mm tall x 215mm long
• End (Header) 65mm tall x 102.5 width

Sounds funny dimensions but makes sense when you add a 10mm mortar join.

• Height 75mm (3") with one joint
• 2 bricks end on with one joint between = 215mm (length of stretcher face)
• One stretcher face with joint - 9"

Of course bricks are not millimetre perfect but there is a British Standard on tolerences but if you bricks are slighlty smaller or larger you take up the difference in the mortar bed joint.

If like us you find brick laying very hard, cheat. Use engineering bricks which can be cleaned off with a wire brush after the mortor has set. Many face bricks are ruined if you get mortar on them.

Paul Middleton